Socket Scanner - Reset

Below are the instructions to reset your scanner and place it under Keyboard mode on your device:

1.Please remove/delete/unpair the CHS device from your bluetooth settings on your device.

2.Do both resets below:

Factory Reset
Reverts CHS back to factory default state. 

1.Power on CHS.
2.Press and hold down the Trigger button and  press the Power button once while still holding down the Trigger button.
3.After 15 seconds, the scanner will beep. Release the Trigger button.
4.The scanner will beep 5 times and power off.
5.The next time you power on the scanner, it will take longer than normal. After the scanner finishes powering on, it will have factory default settings.

Pairing Reset
Releases the Bluetooth pairing from the last system the CHS was paired to. This allows new pairing to another system.

1.Power on CHS.
2.Press and hold down the Trigger button and the Power button at the same until you hear a series of 3 beeps.

3.Turn your scanner on and go to your bluetooth settings on your device to pair.