PowaPOS T25 Pairing with TabPOS

Owned by Navik Prakash (Unlicensed)
Last updated: Jun 12, 2015 by Eric Guzman (Unlicensed)
2 min read

Below are the steps for setting up your TabPOS with the PowaPOS T25 Hardware.  


Note: The pairing steps must be started with the tablet unplugged from the Powa Station and USB. If you have already connected everything - please unplug the USB from the Tablet and unplug the PowaPOS Station from the power, then proceed with the following steps. Unplug the PowaPOS from the source of the power - straight from the wall outlet. Do not just remove the power from the back/connector as this will not fully allow it to power down. When pairing Bluetooth Scanner make sure other Bluetooth devices are not paired on the same tablet it will cause conflict and scanner will not work on TabPOS.

 

Pairing the PowaPOS Station:

  1. Register your TabPOS.

  2. Login to the TabPOS application and navigate to the TabPOS Settings and select Hardware Configuration > Devices- enable PowaPOS and save your settings.

  3. Plug in the power to the PowaPOS Station and wait 30 seconds.

  4. Plug in the USB coming from the PowaPOS Station.

  5. You should receive the following pop up:



  6. You have successfully paired the Powa Station and should now pair the scanner (see below)

  7. If you did not receive the pop up, turn off your Tablet, unplug the USB coming from the PowaPOS, and unplug the PowaPOS from the power. Next - turn on the tablet, open the TabPOS Application and follow the directions from steps 2 - 4.


Pairing the Bluetooth Powa Scanner:

  1. On your Tablet (this is a tablet setting - and is not in our TabPOS application), navigate to your Android Settings > Bluetooth - be sure to verify that your bluetooth is on.

  2. Select the “Scan” option and now on the Bluetooth Powa Scanner press and hold the circle scan button.

  3. You should now see a Powa Device displayed - tap on it to pair.

  4. You will receive a confirmation message and now you are ready to scan.

  5. If you do not see a Powa Device, please press and hold the circle scan button on the scanner until it turns completely off (stops blinking).

  6. Wait 30 seconds and then press and hold the same button until you hear a beep and it starts blinking.

  7. Now repeat the steps from 2 - 4.